tetralink technologies
Showing 253–260 of 260 results
-
Arduino, Arduino Boards & Components, Development Kits
XL-4015 Adjustable Dc To Dc Step Down 5a Buck Converter With Heatsink
-4%
Arduino, Arduino Boards & Components, Development KitsXL-4015 Adjustable Dc To Dc Step Down 5a Buck Converter With Heatsink
?Key Features :
- Input voltage range?4?38VDC(Note: input voltage not exceeding 38V).
- Output voltage range?1.25-36VDC adjustable.
- Output current:?0-5A.
- High efficiency up to 96%.
- Output power:?75W.
- Built-in thermal shutdown function
- Built-in current limit function
- In-Built output short protection function
- Input reverse polarity protection: None (if required, the high current diode in series with the input).
- Power Indicator:?Yes
- Short circuit protection: Yes (limit current 8A)
- Overtemperature protection: (automatically shut off the output after overtemperature)
- Input reverse polarity protection: No, (if necessary, please enter the string into the high current diode)
- Installation:?two 3mm screws
- Dimensions(LxWxH): 54 x 23 x 15 mm
SKU: n/a -
Arduino, Arduino Boards & Components, Development Kits
XL-6009 Dc To Dc Boost Converter Voltage Booster
-3%
Arduino, Arduino Boards & Components, Development KitsXL-6009 Dc To Dc Boost Converter Voltage Booster
?Key Features :
- Module properties: unfenced step-up (BOOST)
- The input voltage: 3-32 v
- Continuous adjustable output voltage: 5v-35 v
- Input current: 4 a (Max), no-load 18 ma
- Module size: 44.7 (mm) x21.7 (mm)
- Input mode: IN + input level is, the IN ? negative input
- Output mode: OUT + output level is, the OUT ? output is negative
- Conversion efficiency: < 94% (the lower the pressure difference, the greater the efficiency)
- Output ripple: 50 mv (the bigger the higher the voltage, current and ripple)
SKU: n/a -
Single/Full Color (RGB) Panels/Modules, SMD Screens & Tickers
Yellow P10 Single Color Outdoor DIP LED Module For Tickers
-15%
Single/Full Color (RGB) Panels/Modules, SMD Screens & TickersYellow P10 Single Color Outdoor DIP LED Module For Tickers
Key Features
- Full outdoor: IP65
- Size (W x H): 320 x 160 mm (320 x 160cm), 12.6 x 6.3 Inch
- Resolution (W x H): 32 x 16 = 512
- HUB Signal: HUB12
- Volt: 5v DC
- Brightness: 5000 cdm (nits)
- LED: DIP 5 mm
- Accessories: Rubber seal, data wire, power cable
- Can work with control card: U6A, U6B, U60, W60, U61, U62, U64, U6BN, WLP-XUA2, WLP-XUB1, etc.
- Display can Show: Text, Animation word, Time, Count, Lunar calendar
- Support simple animation characters
- Click Here to Download HD-U6A Software HD2018
SKU: n/a -
Single/Full Color (RGB) Panels/Modules, SMD Screens & Tickers
Yellow P10 Single Color Outdoor SMD Module For Tickers
-10%
Single/Full Color (RGB) Panels/Modules, SMD Screens & TickersYellow P10 Single Color Outdoor SMD Module For Tickers
Key Features
- Yellow P10 Single Color SMD Module For Tickers
- Full outdoor: IP64
- Size (W x H): 320 x 160 mm (320 x 160cm), 12.6 x 6.3 Inch
- Resolution (W x H): 32 x 16 = 512
- HUB Signal: HUB12
- Volt: 5v DC
- Brightness: 4500 cdm (nits)
- LED: DIP 5mm
- Accessories: Data Wire, Power Cable, 4-Magnets
- Can work with control card: U6A, U6B, U60, W60, U61, U62, U64, U6BN, WLP-XUA2, WLP-XUB1, etc.
- The display can Show: Text, Animation word, Time, Count, Lunar calendar
- Support simple animation characters
- Click Here to Download HD-U6A Software HD2018
SKU: n/a -
Arduino, Arduino Boards & Components, Development Kits
ZB2L3 Battery Capacity Tester External Load Discharge Type Module
-3%
Arduino, Arduino Boards & Components, Development KitsZB2L3 Battery Capacity Tester External Load Discharge Type Module
?Key Features :
- Power supply voltage: DC4.5-6V (micro USB connector)
- Operating current: Less than 70mA
- Discharge voltage: 1.00V-15.00V, 0.01V resolution
- Termination voltage range: 0.5-11.0V
- Supported current: Maximum 3.000A, 0.001A resolution
- Maximum voltage measurement error: 1% + 0.02V
- Maximum current measurement error: 1.5% ? 0.008A
- Maximum battery capacity range: 9999Ah (1Ah = 1000mAh) greater value is switched by shifting the decimal point, when it is less than 10Ah will display X.XXX, up to 10Ah or more will display XX.XX, and so on.
- Board size: 50 x 37mm
- Finished size: 50 x 37 x 17mm (L x W x H maximum position size, contains copper foot height)
- Board net weight: 28g (including pillars)
- Resistor weight: about 27g (including cable)
SKU: n/a -
Genset Products, Synchronization Units
D700 Advanced Auto-Learning Genset Synchronization Controller
D700 synchronization controller is tailored for the most demanding applications, and it can be used for
- Multi Genset synch & load share
- Mains synchronization
- Single Genset parallel with mains
- AMF unit (uninterrupted transfer)
- ATS unit (uninterrupted transfer)
- Remote start controller
- Manual start controller
- Engine controller
- Remote display panel
- Long term data record on a flash drive
- On-board Input&output extension
- Comprehensive synchronizing & load sharingcapabilities
- Built-in governor and AVR control
- Baseload (kW export) control
- Positive & negative kVAr export control
- Mains (Utility) decoupling protection
- 4-Line backlit LCD text display
- CAN AVR support
- Click Here To Download D700 User Manual
SKU: D700-Synch-TFT-Version -
Automatic Mains Failure Units (AMF), Genset Products
DKG105 AMF Unit (Automatic Mains Failure Controller)
-24%
Automatic Mains Failure Units (AMF), Genset ProductsDKG105 AMF Unit (Automatic Mains Failure Controller)
Key Features
- Automatic engine starting and stopping
- Gas engine support
- Automatic mains failure monitoring
- Automatic load transfer
- Automatic shutdown on fault condition
- Provision for energizing to stop, preheat & choke outputs
- Mains phases voltage limits checking
- Generator phase voltage limits checking
- Delayed over-speed and under-speed alarm
- Digitally adjustable low & high mains voltage limits
- Digitally adjustable low & high generator voltage limits
- Digitally adjustable under-speed & over-speed limits
- Digitally adjustable delay for speed alarm
- Digitally adjustable timers
- Digital display of mains & generator voltages
- Digital display of generator frequency
- Digital engine run-hours display
- Plug-in connection system for easy replacement
- Low cost
- Small dimensions
- Standard panel dimensions, (72x72mm)
- Click Here To Download DKG105 User Manual
SKU: DKG105 -
Automatic Mains Failure Units (AMF), Genset Products
DKG107 Automatic Mains Failure Unit
Key Features
- Automatic engine starting and stopping
- Automatic mains failure monitoring
- Automatic load transfer
- Automatic shutdown on fault condition
- 3 phase mains voltage inputs
- 1 phase Genset voltage input
- Survives cranking dropouts
- Mains phases voltage limit checking
- Generator phase voltage limit checking
- Delayed Overspeed and under speed alarm
- Lamp test
- 50/60Hz operation
- Selectable Oil pressure/Oil level switch
- Sealed front panel
- Plug-in connection system for easy replacement
- Standard panel dimensions, (72x72mm)
- Low cost
- Standard panel dimensions, (72x72mm)
- Click Here To Download DKG107 User Manual
SKU: DKG107
