?Key Features :

1. Motor size: 10*12 (N20 motor)
2. Out Shaft diameter: 2.95mm ?(flat position: 2.45mm)
3. Shaft length: 8mm
4. Weight: 10g
5. Rated load : 200 g.cm
6. Working temperature: -10 degrees – 65 degrees
7. Motor mounting position: horizontal or vertical
8. Reduction ratio : 1:298
9. Rated voltage: DC 5V?
10. Rated current : 36 MA
11. Rated load speed: 50RPM
12. Stall torque: 1 KG.cm
13. Operating voltage range : DC3V-6V

?Key Features :

1. Mechanical structure, easy to install.
2. This car has tachometer encoder
3. With 4 cell AA battery holder and power switch.
4. Can be used for distance measurement, velocity.
5. Can use with other devices to realize the function of tracing, obstacle avoidance, distance testing, speed testing, wireless remote control.
6. Gear Motor reduction radio: 1:48.
7. Size: 22cm x 14.7cm, wheel size: 7cm x 7cm x 2.6cm.
8. Note: motor power supply is 3V~6V.

?Key Features :

1. 1. 1. Temperature Control Range: Minus 50 to 110 C
      2. Resolution at -9.9 to 99.9: 0.1 C
      3. Resolution at all other temperatures: 1 C
      4. Measurement Accuracy: 0.1 C
      5. Control Accuracy: 0.1 C
      6. Refresh Rate: 0.5 Seconds
      7. Input Power (DC): 12V
      8. Measuring Inputs: NTC (10K 0.5%)
      9. Waterproof Sensor: 0.5M
      10. Output: 1 Channel Relay Output, Capacity: 10A

      Best Online Shopping website for W1209 Temperature Controller Incubation Thermostat. Here you get W1209 Temperature Controller Thermostat at a reasonable price in Karachi, Lahore, Islamabad, Rawalpindi, Peshawar, Multan, Faisalabad and all over Pakistan.

?Key Features :

1. 1. 1. sensor adopts TR5000, high sensitivity
      2. sensitivity adjustable digital potentiometer to adjust (blue)
      3. modules can induction block from 0 to 3 cm
      4. 5 V working voltage of 3.3 V
      5. 5a output form the output analog voltage (0 to 5 v) B digital switch output (0 and 1)
      6. Has a fixed bolt hole, the work of the installation
      7. Small board PCB size: 3.5 cm * 1.5 cm
      8. The power indicator light (red) and digital switch output indicator light (green)
      9. Comparator USES the LM393 chips, work stability
      10. Three small plate interface specifications wire (4)
      11. 1 VCC external 3.3 V to 5 V
      12. 2 GND external GND
      13. 3 DO small plate digital output interface (0 and 1)
      14. 4 small AO plate analog output interface (0 to 5 v)

?Key Features :

1. • Voltage ? Supply : 3.3 V/ 5V.
   • Interface 😕I?C, SPI.
   • Sensing Range 😕?2g, 4g, 8g, 16g.
   • Sensitivity:
   • X : 28.6 LSB/g.
   • Y : 31.2 LSB/g.
   • Z : 34.5 LSB/g.
   • Sensor Type 😕Accelerometer 3 Axis.
   • Dimensions : 28 mm x 14 mm.
   • Weight : 10 gm.
   • Ultra Low Power: 40?A in measurement mode, 0.1?A in standby@ 2.5V.
   • Free-Fall Detection.
   • Tap/Double Tap Detection.
   • Flexible interrupt modes mappable to either interrupt pin Measurement ranges selectable via serial command Bandwidth selectable via serial command
   • Wide temperature range (?40?C to +85?C).
   • 10,000 g shock survival.
   • Support 5V/3.3V voltage input, on-board RT9161 power chip, lower pressure drop faster than the 1117, faster load speed of response, very suitable for high-noise power supply environment.
   • User-selectable resolution
   • Fixed 10-bit resolution.
   • Full resolution, where resolution increases with?g?range, up to 13-bit resolution at ?16?g?(maintaining 4 mg/LSB scale factor in all?g?ranges).

?Key Features :

• • Supply Voltage : 8-35 VDC.
  • Current : 1.0A (no heatsink ).
  • Current : 2.0A (with heat-sinking).
  • logic input : 3 ? 5.5V .
  • Automatic current decay mode detection/choice.
  • Mixed with slow current decay mode.
  • The low power dissipation of synchronous rectifier.
  • Internal UVLO(ultra voltage lockout).
  • Crossover current protection.
  • Thermal shutdown circuit.
  • Ground fault protection.
  • Loading and short circuit protection.
  • The optional five-step mode: full, 1/2, 1/4, 1/8 and 1/16.